Help for
Router Configuration Mode
After you set up
your pod¡¯s CISCO 2600 router, in order to advertise the existence of your
subnet to devices outside of your subnet, you should use rip (Routing Information
Protocol) as follows.
¡×
Please refer the diagram in the hint entitled ¡°Frequently Used IOS Commands.¡± to understand how to go into the router configuration mode.
¡×
Type
the following command to enter the router configuration mode.
router rip
¡×
Once
you entered the router configuration mode, please type the following to set up
the version of your rip protocol and advertise your subnet to devices in
190.111.0.0.
version 2
network 190.111.0.0
To configure the Routing Information Protocol (RIP) routing process, use the router rip command in global configuration mode. To turn off the RIP routing process, use the no form of this command.
This command has no arguments or keywords.
No RIP routing process is defined.
The following example shows how to begin the RIP routing process:
router rip
To specify a list of networks for the Routing Information Protocol (RIP) routing process, use this form of the network command in router configuration mode. To remove an entry, use the no form of this command.
The network number specified must not contain any subnet information. There is no limit to the number of network commands you can use on the router. RIP routing updates will be sent and received only through interfaces on this network.
RIP sends updates to the interfaces in the specified networks. Also, if an interface's network is not specified, it will not be advertised in any RIP update.
The following example defines RIP as the routing protocol to be used on all interfaces connected to networks 10.99.0.0 and 192.168.7.0: